Not starting and showing "Sensor" indicator is kind of like a dummy light. It catches all kinds of issues. In my case, it was a broken drum belt. It could've been a bum sensor, bad motor, etc. It doesn't necessarily mean the boards within the top console. Use the diagnostics mode to narrow down the issue (see #1). Hello , I really need your advice my IWDC 6105 washer dryer works for 20 to 30 minutes then it suddenly stop and gives flashing all horizontal lights 1-2-3-4 and start button too with last two vertical lights on
If only the "fill" or "sensing" light is lit then you have reached the last fault code or there was nothing wrong with the washer detected by the control. Next write down your codes and clear them by exiting the washer's diagnostics by pressing and holding the "start" button for about 3 seconds. Now you can do an automatic diagnostic washer cycle.
whirlpool washer lights flashing, Jun 01, 2020 · Whirlpool Top Loader With Locked Door. If you have a Whirlpool top loader and the door is locked with a flashing light, here are some things you’ll need to check: Check the lid switch and striker. The striker is the part that helps press down the lid switch. Make sure it’s not out of alignment.